I found a great article here about the step-by-step process of converting solid cabinet doors to glass. We lucked out and our cabinet doors were panel doors. In the long run, this saved us some substantial money as we were able to change the look of our kitchen without paying a carpenter!
Like I’ve written before always do a test door before proceeding with your actual cabinets. I had several cabinet doors I was removing for good (converting to open cabinetry) so it wasn’t a problem for me. However, if you don’t have a spare door, check out your local Habitat for Humanity’s ReStore where they sell odds and ends for home remodeling for dirt cheap prices.
Husband used a router but if you don’t have one, they are available for rental from tool shops. You can also find them used at tool consignment shops, on sale during Black Friday at Home Improvement stores, and off of Craigslist. They have great uses!
In the following photos, I marked important areas with a black Sharpie so you could better see what we were doing. Lime green lines are to show areas of interest.This work is done on the INSIDE of the cabinet door, not the face.
Measuring off this side joint, you can figure the depth of the long cutting line from the edge of the inside of the cabinet door. We first measured the longest sides of the cabinet door, the short side, and lastly, the short side with the arch.
The Guide Board was adjusted after we checked the router blade at the draw cut line. The router blade is sitting on the inside of the cut line and that is where it should be (click photo for a close up view).
The Router must be moved around the OUTSIDE of a rectangle (or circle) on a COUNTERCLOCKWISE movement.
The Router must be moved around the INSIDE of a rectangle (or circle) on a CLOCKWISE movement.
If you goof up that is okay – the above directions just make it easier for the router to cut.
The first pass of the router doesn’t make the cut we need so we go back for a second pass. This isn’t unusual during the first cut and you can always adjust the blade. We did the two longest sides first, the short side, and lastly the side with the arch. If you look closely at the second pic in this series (click on any photo for a close up) you can see how the panel is made up of fitted pieces:
The doors were painted with chalk paint and went from orange oak stain to an off-white and distressed.
Glass was installed by Robinson Glass with 4 doors: 9″ x 21″ glass inserts with “seedy” (glass with a slight bubble pattern) at approximately $14.50 each panel ($54 total). If doing the glass installation yourself, remember to use a clear silicone caulk.
Want to see more about cabinets? There’s more on the blog right here….